M-Jet Ragnarok Hull Hardware Kit

We’ve built many 3D-printable boats, and the M-Jet Ragnarok is one of our favorites so far! This exceptional boat is designed to work seamlessly with the M-Jet 35 pump by M-Jet Designs, a product that has truly raised the bar for RC jet boat performance. The designer Stepan put in an immense amount of work to develop the M-Jet 35, and the results speak for themselves. This pump pushes some serious water, delivering thrilling speeds of over 60km/h when paired with the Ragnarok hull and the right electronics. The attention to detail and engineering that went into the M-Jet 35 is unmatched, making it a standout choice for any enthusiast.

The Ragnarok is built for high-speed action and precise control on water. It’s perfect for tearing up your local lake, pond, river or stream, and is designed with speed and agility in mind. And here’s the best part: the Ragnarok is FREE to download! Download the build files here and get started!

Each hardware kit includes all the necessary fasteners, heat set inserts, brass tubes, and seals to build your Ragnarok hull. Here’s what you’ll get in each kit:

• 80+ stainless steel screws/nuts/washers (various sizes)
• 16 - m3x5.7x4.6 threaded brass heat set inserts
• 1 - 3x4x20mm brass tube
• 2 - 3x4x30mm brass tubes
• 1 - O-ring 29x33x2

All fasteners are 304 stainless steel, chosen for their enhanced corrosion resistance to ensure long-lasting durability. The screws are all metric sizes with hexagonal drive sockets for easy handling. All included screws are socket head cap screws which fit well in the models recesses - at this time no countersunk screws are included in the hardware kit.

Ragnarok Dimensions:

• Length: 450mm
• Width: 200mm
• Height: 150mm

Looking for the build files? Download them here.
Need a controller? Try the FlySky GT5.

Please Note: Our kits only contain the parts listed above to assist you in your build. Additional parts may be required to complete your project.